Cisco Implementing Cisco Unified Communications Manager, Part 2 v8.0 (CIPT2 v8.0) Sample Questions:

1. What is a prerequisite of AAR deployment?

A) You must have a centralized call processing deployment.
B) Calls must be manually rerouted through the PSTN or other networks when Cisco Unified Communications Manager blocks a call due to insufficient location bandwidth.
C) Clustering must be implemented over the WAN.
D) Calls must be automatically rerouted through the PSTN or other networks when Cisco Unified Communications Manager blocks a call due to insufficient location bandwidth.
E) You must have a single distributed call processing deployment.

2. When configuring Digit Manipulation, where exactly should you apply Digit Stripping?

A) Voice Over Internet Protocol (VOIP) dial peer
B) Non-Facility Associated Signaling (NFAS) interface
C) Plain Old Telephone Systems (POTS) dial peer
D) trunk group
E) globally to all calls
F) voice port

3. Refer to the exhibit.
If an IP phone in San Jose roams to New York, which two IP phone settings will be modified by Device Mobility so that the phone can place and receive calls in New York? (Choose two.)

A) The Device Mobility information is associated with one or more device pools other than the home device pool of the phone, so one of the associated device pools is chosen based on a round-robin load-sharing algorithm.
B) The physical locations are not different, so the configuration of the phone is not modified.
C) The device mobility groups are the same, so the Device Mobility-related settings are applied in addition to the roaming-sensitive parameters.
D) The physical locations are different, so the roaming-sensitive parameters of the roaming device pool are applied.
E) The Device Mobility information is associated with the home device pool of the phone, so the phone is considered to be in its home location. Device Mobility will reconfigure the roaming-sensitive settings of the phone.

4. Refer to the exhibit.

Which CSS is used at the HQ Cisco Unified Communications Manager to reroute calls via the PSTN when the SAF network is unavailable?

A) the phone device CSS
B) the phone line/device combined CSS
C) the SAF CSS configured on the CCD requesting service
D) No special CSS is required. If SAF patterns are accessible, the PSTN reroute is automatic.
E) the phone AAR CSS configured at the phone device
F) the phone line CSS

5. In a Cisco Unified Communications Manager centralized call processing model, what is the best CAC method recommended for this type of deployment?

A) QoS-based
B) region-based
C) gatekeeper-based
D) location-based
E) gateway-based
F) RSVP-based

Solutions: