Prep and try our HPE7-V01 valid and latest training questions & answers

HP HPE7-V01 Exam Overview:

HP HPE7-V01 Exam Syllabus Topics:

HP Advanced HPE Edge-to-Cloud Solutions Written Sample Questions:

Question 1

A customer wants to reduce east-west traffic hairpinning in a data center fabric where most workload communication occurs between servers in different racks. Which Aruba CX data center architecture addresses this most efficiently?

A. A spine-leaf (Clos) architecture with EVPN-VXLAN overlay.
B. A traditional three-tier (core/aggregation/access) architecture.
C. Hub-and-spoke WAN topology.
D. A single flat Layer 2 VLAN spanning the entire data center with no routing.

Question 2

A customer wants HPE Aruba wireless APs to dynamically adjust channel and power settings to minimize interference as the RF environment changes throughout the day. Which Aruba capability provides this?

A. Aruba Adaptive Radio Management (ARM) / AI-driven RF optimization.
B. This capability does not exist in Aruba access points.
C. Static channel assignment configured manually once during installation.
D. Disabling all but one channel across the site.

Question 3

Refer to exhibit from a customer's Aruba CX switch.
show interface vxlan vni vteps
VNI : 150 VLAN : 150
Routing : Disabled VRF : default
Vxlan-status : operational
VTEPs
Origin Source Destination VTEP-STATUS
static 172.17.255.2 172.17.255.1 static operational
Which statement is true in this scenario?

A. A static VXLAN setup needs to be created between the peer switches.
B. An EVPN VXLAN setup will dynamically establish the VTEPs between peer switches.
C. A Foundation license needs to be applied to the switches to scale the VXLAN configuration.
D. A VTEP setup requires the same model of the CX switch on each location.

Question 4

Your customer wants to implement microsegmentation for VMs running on HPE SimpliVity without redesigning their physical network. Which approach is most appropriate?

A. Redesign the entire physical network with new VLANs for every application tier.
B. Rely solely on physical firewall ACLs at the core switch.
C. Microsegmentation is not possible in virtualized environments.
D. Use VMware NSX (or equivalent software-defined networking) integrated with the SimpliVity/vSphere environment for microsegmentation.

Question 5

You are designing a solution for a customer that will support a virtualization workload based on HPE Synergy. Your customer has the following requirements:
Dual-socket HPE Synergy compute nodes running ESXi 8.x with maximum
memory supported
Each node should have access to shared storage from HPE Alletra Storage MP B10000 All virtual machines should be protected against host failure All virtual machines with vGPU must be protected with Fault Tolerance All compute nodes should boot from drives located in the D3940 Storage Modules protected with RAID 1 All frames should be managed as one logical enclosure to simplify management All compute nodes should support two network ports with the maximum Ethernet connectivity speed You are reviewing a proposal that you must verify. The proposal contains:
3 HPE Synergy 12000 frames
2 HPE Synergy Composer2 modules
4 HPE Virtual Connect SE 100Gb F32 Modules for Synergy
4 HPE Synergy 50Gb Interconnect Link Modules
3 HPE Synergy D3940 Storage Modules, each with 20 SSD drives
1152 core vSphere Enterprise Plus subscriptions
36 HPE Synergy 480 Gen11 compute nodes
Each SY480 Gen11 is configured with:
A single Platinum CPU with 32 cores
HPE Synergy 6820C 25/50Gb Converged Network Adapter
HPE Synergy 5830C 32Gb Fibre Channel Host Bus Adapter
HPE MR416i-o Gen11 12G SAS Mezzanine Controller
Which two statements are true regarding the proposal? (Select two.)

A. To access HPE Alletra MP B10000 arrays, FC upgrade licenses for HPE Virtual Connect SE
100Gb F32 Modules for Synergy must be purchased.
B. vSphere Enterprise Plus subscriptions can be replaced with vSphere Standard subscriptions.
C. Two HPE Virtual Connect SE 100Gb F32 Modules for Synergy can be removed from the proposal because all requirements are met without them.
D. HPE MR416i-o Smart RAID controller can be removed because there are no external SAS disk enclosures included in the proposal.
E. 2 HPE Synergy 50Gb Interconnect Link Modules should be removed from the proposal, as the total number of interconnects required is six.

Solutions: